欢迎访问润滑与密封官方网站!

咨询热线:020-32385313 32385312 RSS EMAIL-ALERT
基于泄漏率的垫片系数试验及分析
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

国家自然科学基金面上项目(51675183);国家重点研发计划专项(2017YFF0210400).


Test and Analysis of Gasket Factors Based on Leakage Rate
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    在ASME标准中,采用了基于强度的满足泄漏率等级的垫片系数m和垫片预紧应力y,而没有考虑到接头的泄漏率要求。研究基于泄漏率的垫片系数m(L)、垫片预紧应力y(L),以及EN1591-1中提出的基于泄漏率的安装条件下垫片最小应力和服役条件下垫片最小应力;采用金属缠绕垫片进行基于泄漏率的垫片系数试验,推荐一种基于泄漏率的m(L)、y(L)的测试方法。根据该试验方法和EN13555提出的方法进行垫片系数的试验,并对2种体系下基于泄漏率的垫片系数进行比较。结果表明:基于泄漏率方法得到的m(L)、y(L)值,在低泄漏率要求等级下是可靠的,可供工程实际参考使用。

    Abstract:

    In ASME standard,strengthbased gasket factor M and gasket prestressing stress y satisfying the leak rate grade are adopted,however,the leak rate requirement of joints is not taken into account.The leakage rate based gasket coefficient m(L),gasket prestressing stress y(L),and the minimum stress of the gasket at installation and service conditions based on leakage rate proposed in EN1591-1 were studied.The test of gasket coefficient based on leakage rate was carried out with metal wound gaskets,and a test method ofm(L) andy(L) based on leakage rate was recommended.According to the test method and the method in EN13555,the gasket coefficient was tested and compared.The result show that the values ofm(L) and y(L) obtained by the test method based on leakage rate are reliable under the low leakage rate requirement level,which is available for practical engineering.

    参考文献
    相似文献
    引证文献
引用本文

纪一丹,章兰珠.基于泄漏率的垫片系数试验及分析[J].润滑与密封,2019,44(8):99-103.
. Test and Analysis of Gasket Factors Based on Leakage Rate[J]. Lubrication Engineering,2019,44(8):99-103.

复制
分享
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 最后修改日期:
  • 录用日期:
  • 在线发布日期: 2020-03-12
  • 出版日期: